Since 1977
A trailer that tows badly is usually a hitch problem, not a driving problem. Weight distribution, sway control and a correctly set brake controller are what turn a nervous tow into an uneventful one, and all three have to be matched to the actual loaded weight of your trailer and the specification of your tow vehicle.
Our hitch shop sizes and installs the whole setup, then sets it up with the trailer attached rather than handing you a box of parts.
What the work covers
- Weight distribution hitch sizing and installation
- Sway control setup, adjusted with the trailer loaded
- Brake controller installation and gain setting
- Fifth wheel hitch installation, including rail and puck systems
- Receiver hitch and wiring installation on tow vehicles
- Pin and tongue weight measurement against your payload rating
- Bearing repack and trailer brake inspection
Hitch Shop at all 10 Supercentres
Book at whichever shop suits you. Each page carries that location's direct service line, hours and the campsites worth knowing about nearby.
How the job runs
- 1BOOKSchedule drop off appointment with advisor.
- 2IN-TAKEInitial walk-around and documentation of your concerns.
- 3DIAGNOSIS & QUOTEFull inspection, then an estimate with parts and labour broken out.
- 4PROFESSIONAL REPAIRRepairs done with OEM parts and the factory procedure.
- 5QUALITY TESTA second set of eyes checks the work before it leaves the bay.
- 6ACTIVE DELIVERYWe walk around the unit with you and show you what was done.
